Most of the time when your tool gets a little dull the honing step is where you’ll start. Like a lot of folks I eventually came around to the idea that the best tool for hand sharpening and honing is a piece of glass with sandpaper glued to it with spray adhesive. Using a tool like this means you always have a sharp, flat and big sharpening surface to work on.

  • Thereafter, sharpen the bevel, working your way up through finer and finer abrasives.
  • Cut a positive profile into the board using the gouge that is to be sharpened.
  • There are a great variety of sharpening materials available—all manner of electric grinders, natural and man-made stones and honing compounds.
  • You can also create U-shaped grooves on one side of your water stones.

I highly recommend them; however, I also believe that everyone ought to understand some of the theory of sharpening so they can use jigs successfully. I’ve seen some weird profiles produced by ostensibly fail-safe sharpening jigs! Recently at a hands-on workshop I spied a bowl gouge sharpened to a wicked point. I asked the owner (name to remain anonymous for obvious reasons!) why the tool was shaped like that. I use a fairly fine grinding wheel to sharpen all my curved woodturning gouges.

Introduction: Simple Gouge Sharpening And Restoration Tricks

This type of grind is best achieved using the Vari-Grind Attachment. Sharpen the Bevel Holding the bevel down on the stone, gently rock the tool until you have found the angle where the bevel is flat against the stone. Press down on the end of the tool with the fingers of your free hand to keep the bevel flat against the stone.

sharpening gouges

An introduction to grinding wheels and slow-speed grinders will help set the stage so you can achieve success. You’ll discover that a good quality cutting edge can be obtained right off the grinder. You can use a grinder to sharpen a gouge but I would be extremely careful about doing this with any high-speed grinder, no matter how fine the wheel fitted is. Doing it manually is lots slower, but much more controllable. Your bowl gouge may have a completely different grind, and profile and that is fine. We are here to understand bowl gouge sharpening techniques, regardless of angle or profile.

How To Sharpen And Use A Drawknife

The edge is constantly being dipped in the water during the operation. In general I find that the tool should not be in contact with the disk for more than a second before the tool is dipped into the water. If you see the metal start to turn colors it has already gotten too hot.

sharpening gouges

Sharpening a gouge can be tricky because its edge is not flat. While it may take a while to get the hang of sharpening your gouges, it’s a necessary and beneficial skill to master. @DaveSmylie, the curved-edged how to strop a blade slipstones can wear unevenly, but in use the shape of the gouge tends to wear the stone edge to match. You can also do it just by rolling the bevel on the abrasive as you move the blade back and forth sideways.

Simple Gouge Sharpening And Restoration Tricks

We do not want color to appear on the steel of our bowl gouge. 6) Take a marker and color the surface of the bowl gouge bevel. That’s an amazing amount of cutting and performance from a piece of steel.

girl in orange dress lying on bed

Enter your email to receive our powerful sleep trick

This trick will allow you to fall asleep in less than 2 minutes. It's so powerful, the army is using it!

Your the best: Check your email!